State of the database, as of August 23rd 96 : Size of the binary part of the base (in Kbytes) : 1250576 Binary or, 117129 0cal 405173 0fix 117022 21cal 205720 21fix 405531 6fix Detail of the available data : Number of successfully processed variables MODEL 0cal 0fix 6fix 21cal 21fix ccc2.0 231 231 ccm1 216 216 ccm3 210 210 ccsr1 276 276 276 <- NEW cnrm 215 213 echam3 222 224 224 <- UPDATED gen1 192 192 gen2 240 240 237 240 225 <- UPDATED giss-iip 139 139 139 lln_nh_1 40 lmcelmd4 186 186 184 <- UPDATED lmcelmd5 192 192 190 <- UPDATED mri2 282 282 236 ugamp 254 254 254 254 254 uiuc11 269 272 <- NEW ukmo 255 255 yonu 255 248 Notes : * sftland has been added to lmcelmd4_0fix * [pot,stf]uv have been removed from lmcelmd[4,5] and will have to be corrected * variances for lmcelmd[4,5] will have to be checked (again)... Some may still be wrong * sftland and sftlandT31 have been added to gen2 sftland -> surface -> 180*90 sftlandT31 -> agcm -> 96*48 NOTE that the two grids supplied are shifted to the west! See the attached mail from Rich Selin at the end of this mail. Is this the case for other models?... * echam3_0fix has been completely replaced (insolation was wrong) * uiuc11 model has been added to the base * ccsr1 model has been added to the base JY Message 133/134 From Rich Selin Aug 19, 96 02:12:34 pm CDT To: jypeter Subject: Re: gen2_*_sftland JY, > But was all the data (the new sftland, and the other variables) > written with the same list of longitudes (we want to be sure that we > mask only what we should mask, when we use sftland!). Everything > should be fine if this is actually the case. Yes, ALL the AGCM data (3.75 Degrees, or 48x96) was written the same way, with the WRONG longitudes. It should start at 1.875 East instead of 0 East. Some of the data was obtained from the LSX part of the Genesis2 model. I just found out from Dave Pollard that the LSX is ALSO wrong. It starts at 1 East where I had put it starting at 0 East. So both portions (AGCM and LSX) of Genesis 2 have the western edge of their first grid box start at 0 East, NOT be centered on 0 East. Here is a list of PMIP variables written from AGCM data that have the wrong longitudes: orog sftland rsdt rsut rlt rsds rsus rls hfss hfls pr prc evs pmsl usfc vsfc hursfc clt rltcs rstcs rlscs prw zg ta u v hus hur These variables are from the LSX and also have the wrong longitudes: snow seaice sim snm mrro tas tg tauu tauv Rich